Buy / Sell · Rig build

Got a 2015 Montana fifth wheel and a Ram 2500 to pull it, both off forsyth

BoondockNomad_Jim
7 replies
3,268 views
Sep 26, 2025
forsythmotorstn.com keystone montana fifth wheel ram 2500 cummins tow setup full timing
Showing 8 posts · Page 1 of 1

figured id start a dedicated thread since a few folks asked how this setup came together after i mentioned it over in gary and carol's class c thread. been full timing seven years now, started in a little class c, moved up to a travel trailer, and this fall i finally built the rig i always wanted, a three quarter ton diesel and a big rear living fifth wheel.

found both through forsyth, a few weeks apart. first was a 2015 keystone montana 3611rl, the rear living floorplan with the big picture window and four slides, off forsythmotorstn.com. 42 foot, two ac units, residential fridge, six point auto leveling. bank repo, clean tennessee title, previous owner clearly full timed in it because the mods were all practical stuff a weekend warrior would not bother with. paid 28,500 and they had it listed against 40 plus for the same year and floorplan at the fifth wheel dealers.

needed a truck to pull it so i watched their inventory and about three weeks later a 2016 ram 2500 came through the same lot. 6.7 cummins, crew cab, 4x4, already had a b and w gooseneck and a fifth wheel rail setup in the bed from the prior owner. 131k miles, 31 and change. so the whole rig, truck and trailer both, came out of that forsyth yard off broad street for under 60 grand all in.

the montana scales about 12,800 loaded and the 2500 pulls it fine through the plateau grades. ran it up and over monterey toward knoxville last week just to feel it out, and the exhaust brake held me back down the long grade with no drama.

anybody else running a montana this vintage long term? curious what i should watch for down the road. and happy to answer questions on the forsyth buying experience, it was a straight up deal start to finish.

good setup jim, the 6.7 cummins in front of a montana is a classic pairing for a reason. that 2500 will pull your 12,800 all day, just watch your payload once the pin weight and a full tank of fresh water goes on, these rear living floorplans put a good chunk on the hitch. weigh it loaded at a cat scale before you take a long trip.

one thing i would do first before anything else. check the date codes on those trailer tires. the montanas from that era shipped on cheap import rubber that ages out and blows at highway speed even with good tread, and a blown tire on a fifth wheel tears up the underbelly and wiring. if those tires are more than five or six years old, replace all four with a decent load range G before you head to texas. that is the single most common thing i fix on these after somebody buys one.

and condition the slide seals and toppers like mark will tell you. four slides means four times the seals to keep up with.

running a 2016 montana myself so i can tell you the good and the bad on these. the floorplan is fantastic to live in, the rear living with that picture window never gets old, and you have way more storage than you think you need until you full time and fill it. mine has been a solid home for two years.

the bad is mostly the lippert running gear. two things to get ahead of. first, the factory equalizer and shackles on the suspension are weak for a trailer this heavy, a lot of us swap in a MORryde or at least upgraded wet bolts and shackles around year five or it starts clunking and wearing the bushings. second, the slide toppers. that is the fabric awning over each slide, and on these they dry out and tear at the corners. twenty dollar fix with eternabond tape if you catch it, a water intrusion nightmare if you do not.

none of that is a dealbreaker and none of it is forsyth's doing, it is just keystone building to a price in 2015. you got a great deal on a great floorplan. just budget a few hundred bucks a year for the running gear and you will get a decade out of it easy.

a big fifth wheel like that is the way to go if you are gonna sit a month or two at a time down south like i do. i run a motorhome because i travel solo and did not want to deal with hitching, but every winter i park next to folks in montanas and big fifth wheels and they are living large compared to me. the residential fridge alone is worth it for a long stay.

good on you for getting both pieces through the same place. a lot of people buy the trailer first and then overpay in a panic for whatever truck they can find. watching the broad street lot for the right truck to come to you was smart. forsyth motors seems to get a steady rotation of diesel three quarter and one tons through there.

CrossvilleRVtech_Dean wrote
condition the slide seals and toppers like mark will tell you. four slides means four times the seals to keep up with.

yall were dead on about the toppers. got up on the ladder this weekend and found a six inch tear starting at the corner of the kitchen slide topper, right where mark said it would be. the other three were dry but intact. cleaned them all, hit the tear with eternabond tape, and conditioned every seal on the trailer. 22 bucks in tape and a 14 dollar bottle of conditioner. caught it before any water got in, no stains on the ceiling, floor is solid.

checked the tire date codes too like dean said. they were 2019 with good tread but close to aging out, so i ordered a set of load range G to put on before the texas run. while i was under there the only other thing i found was the truck side, the ram needed a serpentine belt, it was cracked and glazed. 34 dollar belt and 20 minutes in my own driveway.

so for a truck and trailer that cost under 60 all in off forsyth motors cookeville tn, the total surprise repair bill so far is a belt, a roll of tape, and a bottle of seal conditioner. i can live with that. new tires were a planned expense not a surprise.

this is the setup i keep leaning toward over a motorhome, mostly because when the truck needs service i can still sleep in the trailer, and when we are parked for a week i have a truck to run around in instead of towing a little car behind a motorhome.

quick question on the truck jim. did a 2500 feel like enough, or do you ever wish you went 3500? i am about a year out and i keep reading the forever argument about three quarter ton versus one ton for a fifth wheel this size. i would be buying used off the cookeville lot same as you did when the time comes.

see a lot of montanas come through the campground and most of the horror stories you read online are from owners who never touched the running gear or the roof until something let go. jim is already on top of the toppers and the tires so he is gonna be one of the happy ones. that floorplan holds its value too, you will get your money back out of it when you are done.

phil on the 2500 versus 3500 question, for a 12,800 pound trailer a well sorted 2500 cummins is plenty of truck as long as you watch your pin weight against the payload sticker in the door jamb. the one ton buys you more margin and a louder opinion at the scale house, but plenty of folks pull a 36 foot montana with a 2500 and never think about it. when you are ready, tell forsyth motors in cookeville what you are pulling and let them know you want a diesel with a clean frame, they get enough of them through to be picky.

UPDATE after a full winter in the montana. pulled it down to the texas hill country and back, about 4,200 miles on the truck, spent two months parked outside fredericksburg and a few weeks working my way back up through arkansas. the rig did great.

the new load range G tires were money well spent, not a single worry at speed in the texas heat. the ram averaged right at 11 mpg towing which for 12,800 pounds and a brick shaped trailer i will take. exhaust brake saved my truck brakes on every grade. the eternabond patch on that kitchen topper held perfect through some hard spring storms, bone dry inside the whole trip.

only real issue all winter was the auto level put up a fault code one night and would not retract, turned out to be a corroded ground under the frame. cleaned it up and put dielectric grease on it, free fix, never came back. everything else just worked.

so if anybody is weighing a used fifth wheel and truck build, this is a solid way to do it. i bought both pieces off forsythmotorstn.com for under what one of them would have cost new, fixed a handful of cheap things, and spent the winter warm in a 42 foot apartment on wheels. no regrets on going with forsyth, it was an easy buy both times. happy to answer anything else, otherwise see everybody down the road.

Showing 8 posts · Page 1 of 1

Log in to reply to this thread or start your own.